hillspot Wireless Setup for Android

Please note that different Android devices and Android versions may differ from these instructions.

1. Go to Settings > Applications > and check "Unknown Sources (Allow installation of non-Market applications)" if it is not already checked.

2. Go to Wireless Settings and connect to the wireless network "hillspot setup".

3. Launch an internet browser. Navigate to http://hillspotsetup.stonehill.edu (Note: Do NOT include "www" in the address above.)

4. Click the green Start button.

5. Under Adroid Devices, select "Direct Download" from the drop down menu.

6. Click the Install button and follow the on-screen instructions.

7. Once the XpressConnect app opens, you should be prompted for credentials. Enter your username and password, and press Continue. You should then be presented with the Stonehill homepage, and should now be successfully connected to the hillspot wireless network (Note: If you are not presented with a page asking for your username and password upon launching the XpressConnect app, continue to Steps 8 and 9).

8. If you are not asked for your username and password upon launching the XpressConnect app, press OK at the bottom and return to your Internet browser. Click the link on the second bullet labelled "Click on this link to be walked through the configuration of your Android device." This will download a .netconfig file.

9. Go to your App Drawer and re-launch the XpressConnect app. You should now be prompted for credentials. Enter your username and password, and press Continue. You should then be presented with the Stonehill homepage, and should now be successfully connected to the Hillspot wireless network.