1. Connect the VGA Cable with the audio connector into “Input 1”on the projector. Connect the other end of the VGA cable to your laptop.
    1. Connect the “stereo mini” audio cable to the headphone out port on your laptop if you need audio and into the corresponding audio port on the projector.
  2. Turn the projector on by pressing the “ON” button on the top left side of the projector. The projector will take few minutes to power up.
  3. Raise the "pull up" projector screen, located near the window.
  4. Make sure projector is properly lined up and is about 2 feet away from the screen. 
    1. Please note that this is a “short throw” projector. It should not be too far away from the screen.
  5. Set your computer's screen resolution to 1024 x 768 for the proper size from the projector.
  6. Once you are done with your presentation, press the “OFF” button on the projector.
  7. The projector will power down for a couple of minutes. Do not unplug it until the fans stop spinning.
  8. Disconnect your laptop and make sure all equipment is off.